Assembly & Installation Cut the tube square using a nylon tube cutter. Slide the tube through the collet into the fitting. Slide the tube firmly through the O-Ring until it rests against the tube stop. …

Assembly & Installation Cut the tube square, clean and remove any burrs or loose cuttings. Slide tube nut over the tubing. Using a 45° flaring tool, flare the end of the tube (as per tool …

Nylon Poly tube Assembly & Installation Cut the tube square, clean and remove any burrs or loose cuttings. Slide tube nut over the tubing. Using a 45º flaring tool, flare the end of the tube …

All John Guest products should be installed as per the installation instructions and within the prescribed operation conditions as detailed in the appropriate technical manual section.

Assembly & Installation Tighten fitting to ‘spanner firm’ position. (Caution: do not over-tighten) If used in a pneumatic application, apply a soapy solution to the joint to be certain a positive seal …

Aluminium Brass Steel bundy Stainless steel Assembly & Installation Cut the tube square, clean and remove any burrs or loose cuttings. If using metallic tube, move to point 3. If using non …

Assembly & Installation Tighten fitting to ‘spanner firm’ position. (Caution: do not over- tighten) Ensure Barb is fully inserted into the hose.

Installation is subject to the requirements of the applicable regulatory authority, the National Construction Code Volume Three – Plumbing Code of Australia, associated reference …

TubeFit Industrial Products provide a wide range of hose & fitting solutions to suit all industries.

To ensure fittings stay clean and the O-Ring is protected from damage, fittings must be kept in their original packaging until immediately prior to installation .